Renovating 1950-70s Style Houses

A lot of homes of this period have reserved their character and look – strongly influenced by state housing. However, changes are often needed and could make a huge difference in the performance of the property.

A huge percentage of the houses built during the 1950s, 60s, and 70s will need updating to bring them up to modern standards of efficiency and comfort. A benefit when renovating style houses build during this years is that the original drawings are available often. That is something which is normally lacking for homes constructed in earlier periods.

Layout and Design

State housing dominated between the 1950s and 1960s and a wide array of state house plans are accessible. The concept was that state housing must not look all similar, to prevent the look of mass-produced government housing. Even though the form and layout varied, typical themes include:

  • small windows
  • orientation for sun
  • efficient layout
  • family small size and
  • a roof with a 30-degree pitch

Other common features might include service areas, minimal space committed to hallways, and recessed porches group together.

Typical Issues and Remedies

Structural issues in the 50s and 60s style houses might include dangerous chimneys, insufficient bracing and undersized framing. Any renovation work must start along with a thorough survey of the building structure. When there is any proof of structural defects, then a structural engineer might be needed to engage.

Normally, houses in this era have a good roof slope and eaves to shed water and generous ground clearance for the subfloor ventilation. These were constructed with the use of quality heart timbers. Nevertheless, the introduction of the new methods and materials of construction throughout the 60s means there were insufficient durability and experimentation of several materials. That also denotes that most of such homes might not have done as anticipated.

Along with renovations, attention should be paid to the ventilation. It will guarantee that the internal moisture doesn’t become an issue. Other problems to pay attention during the renovation will over dealing with fewer roof pitches if they’re under the present minimum slope requirements, the need for a cavity when matching present work and the lack of a roof and wall underlay.

Houses built in the 50s to 60s were not insulated. Any additions created after 1978 must have insulated ceilings and walls and might have underfloor insulation and roof space. However, the level might fall short of present standards. You see, there’s no required requirement to upgrade the insulation of the current parts of the house. Nevertheless, all new work should meet the present standards. A wide array of insulation choices is accessible for underfloor areas, walls, and spaces.

Original copper pipes will possibly don’t need replacement. However, plastic pipes installed throughout renovations in the 1970s may. When renovations are being performed, the hot water system must be transformed into the main pressure system. What’s more, the fittings and the pipework must be checked for their capability to cope with the added pressure. It might be needed to change the fittings as well.

Ultimately, the roofs will require maintenance and might need some replacement. On the other hand, weatherboard cladding tends to remain in good condition when maintained properly. Brick claddings might have corroded ties or might be cracked, and asbestos cladding might need some replacement.

So, if you prefer to renovate houses built in the 1950s to 70s, consider all these points we mentioned.

Close Menu